Sandblasting Gloves 6030/12ECO 30″ Long Sandblasting Gloves

Description

 Sandblasting  Gloves – specs.

• Vinyl gauntlet 18″ Long from top of glove
• Width at top of gauntlet 12″
•  
• Overall length 30″.
• Glove Length 14″
• Glove Finish: Neoprene
•  
• Color: Black.
• Pricing: Pair of 2 gloves, one left and one right.

When blast cleaning in cabinets and other areas it is important to protect hands and arms with sandblasting Gloves. These 30″ long glove with gauntlet provide protection against media bounce back or ricochet.

Always wear OSHA approved protection when sandblasting with abrasives. 

Suggested Good Nozzle Practice.

1. Your new carbide lined sandblasting nozzle is supplied with a nozzle washer. Place threaded end of nozzle up against end of abrasive blast hose in nozzle holder. There should be 100% surface contact between nozzle washer and top of hose. (See picture below)  When installed correctly the sandblasting nozzle washer will help prevent wear at blast cleaning nozzle entrance.
2. Always inspect equipment & replace worn hose, nozzle holders, washers & carbide sandblasting nozzles.
3. To maintain productivity always replace your carbide sand blasting nozzle when inside bore has worn to one size larger than originally supplied. (1/16″ /1.59mm)
4. To avoid injury/harm when blast cleaning, always follow all statutory & other established safety rules covering blast cleaning operating procedures.
5. To avoid injury/harm when blast cleaning, always follow all statutory & other established safety rules covering the selection & use of equipment & media.
6. When using and cleaning sandblasting / blast cleaning nozzles do not bang/impact them as this may crack or fracture the carbide liner.
7. Please remember the blast cleaning nozzle is a tool and should be protected against damage like any other tool.
8. Always check carbide lined sandblasting nozzles before using for excessive wear, cracked or broken liners. Always replace nozzles when you see the liner has been damaged, cracked or otherwise compromised.
9. Before screwing nozzle & holder together, clean threads of grit etc. Make sure you use the supplied washer and replace when worn. The washer insures a good seal between the bottom of the blast cleaning nozzles and hose.